Elmo HV-3000XG Instruction Manual download pdf (Page 20)

Remote control

Powered Manual Focus

To focus on any part of the material, such as 3-D

material, press the focus button [NEAR] or [FAR] on

the wireless remote control.

Reference OSD menu P.22

Note: The auto focus function works up to a height of

approx. 15 cm (5.9 in.) above the stage

surface on the maximum side of the zoom

[TELE] (when a close-up lens is attached).

Iris

The iris level can be adjusted.

To open the iris, press the open button [OPEN] on the

wireless remote control.

To close the iris, press the close button [CLOSE] on the

wireless remote control.

To reset the setting to the initial setting, press the auto iris

button [AUTO IRIS] on the wireless remote control.

Reference OSD menu P.22

Note: If the screen looks dark, press the iris button

[OPEN] on the wireless remote control to adjust

the brightness of the screen.

Remote control

However, the objects listed below may not be brought

into focus in the auto focus mode. In these cases, use the

manual focus mode.

· Objects bearing little contrast

· Objects with fine repeated patterns, such as lateral

stripes and cross stripes

· Objects glittering or reflecting strong light

· Objects with bright background, or excessive contrast

· Objects in a dark picture plane

· Objects located near and far away at the same time.

· Objects in motion

If the focus button [NEAR] or [FAR] on the wireless

remote control is pressed while the auto focus is in

operation, the auto focus will be released.

Note: The auto focus functions up to approx. 15 cm

(5.9 in.) above the stage surface (with the

close-up lens attached).

Remote control

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

No comments

Elmo HV-3000XG Instruction Manual Page 20