Elmo TT-12 User Manual download pdf (Page 2)

ELMO TRAINING SESSION # 7

December 12, 2008

THE PROPER SET UP OF THE TT-02s IN YOUR CLASSROOM

The most important question that any teacher has once they open up the ELMO TT-02s is “How do I set it up”. This pape

will discuss the proper way to hook the ELMO TT-02s up to both a Laptop and a projector.

First, the number one question that we get at ELMO is do I need a projector or monitor to view the information that will come

from your document camera. The answer is YES! This product is much more than a overhead camera. The TT-02s is a digital

piece of equipment that has no built in projector.

There are two ways to hook the ELMO TT-02s to a projector. The following directions will let you use ALL the features this

very special classroom product.

Unpacking the TT-02s

There are several rules when opening up your new Elmo TT-02s.

• Unpack everything before hooking anything up

• Take the TT-02s out of the box and place it on a table

• IMPORTANT! Move the camera arm parallel to the table and ROTATE the camera 180 degrees so that

the camera is now in the proper operating position. ( Image #1)

• Read through the manual.

• Read the software manual. Note that MAC software can be found on our web site www.elmousa.com

. (

Image #2)

• Save the shipping box. The box is built to house the TT-02s should you need to send it back for service

• Save everything that came in the box!

SETTING UP THE TT-02s

We see teachers setting up the TT-02s in many different ways. We want you to set it up as follows:

PROJECTOR ONLY

• If you are only hooking the TT-02s up to a projector use the 15

in RGB cable directly from the RGB out on

the TT-02s to the RGB in on the projector. You can use the RGB cable that came with the projector.

• Plug in the Power supply for the TT-02s.

• Turn the TT-02s and the Projector on.

• After the projector warns up you will see an image on the wall or screen.

• If you do not see any image make sure that the Projector is set to show the RGB video ( Computer/ XGA

etc) that you are hooked through. You can press the set up button on the Projector until you see an image.

• You are ready to GO!

1 2 3 4 5 6 7 ... 24 25

No comments

Elmo TT-12 User Manual Page 2