Elmo Vandal Resistant Dome Camera TND4204VX User Manual

VANDAL RESISTANT DOME CAMERAINSTRUCTION MANUALThe exclamation point within an equilateral triangle is intended to alert the user to the presence of im

9166(6.54)101.6(4.00)AppearanceAll dimensions in mm(inch)When any failure is suspectedSymptomsImage is not displayed.Color is not correct.Image is dis

10SpecificationsPower sourcePower consumptionImage pick-up deviceEffective picture elementScanning areaScanning systemScanning frequencySync.systemRes

116X1NSVA02 Printed on recycled paperPrinted in CHINAELMO (Europe) G.m.b.H.Neanderstr. 1840233 Dusseldorf,GermanyTel. 0211-376051-53Fax. 0211-376630E

1IMPORTANT SAFETY INSTRUCTIONS1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5. Clean only with

2Name and Function of Each part123456No.Name FunctionThe mounting bracket for ceiling installation.The main body of the camera section.For adjusting t

378912101113171715161614Used when the white balance is in the PUSH mode.For setting the vertical sync. phase.For adjusting the brightness of the image

4Selector switch (Details)1.SENS UP switchTo set the max. value (upper limit value) of theoperating gain in the auto gain control circuit, set thisswi

5How to Install1. Make holes in the mounting surface. (Fig. 1)The paper pattern for installation isincluded.2. Remove the dome cover main bodyfixing s

Camera mountingbracket mountscrew(not attached)Front ofcameraCameramountingbracket63. Remove the main body fixing screws,and remove the main body from

Base panLens(Fig.7)Camera mounting bracketBNCcablePower cordMain body75. Connect the power cord and the BNCcable, and then mount the main body onthe c

8Be careful not to drop the tilt lockscrew.Manually fasten the tilt lock screw.If fastened with pliers or the like, the tilt lock screw may be broken.