33
・ When the product does not recognize the PC, turn off the product and turn it on
again.
・ Depending on the environment of your PC, the product is not recognized when
the PC is in standby status or in sleep status. Make sure to cancel the standby
setting or the sleep setting before connecting to the product.
6 USING A USB
Installing the software
Install the control software “Image Mate” contained in the supplied CD-ROM onto
your PC to connect the product to a PC.
For details about the operating environment and the OS of the connected
computer or the operation of the software, refer to the installation manual of
Image Mate.
Connecting to a PC
Set up the product as shown in the above drawing and turn on the power after
connecting a PC.
Comments to this Manuals