38
8 TROUBLE SHOOTING
If you have a problem or questions about this product, please read this troubleshooting
guide first. If the problem still exists, consult the dealer from whom you purchased this
product.
• The cable is not properly connected.
• The AC adapter is disconnected from the wall outlet.
• The AC adapter is disconnected from the power supply
socket of the unit.
• The power is not ON. (Blue light)
• Zoom is set at the TELE side, displaying only the
white/black part of the document.
• If you turn the power ON immediately after turning it
OFF, the unit may not start. Wait for several seconds after
turning the power OFF, and then turn it back ON.
• The setting of the Image Selection does not correspond to
the video cable connected.
• Reconnect the AC adapter.
• When the power is supplied from USB, check if the USB
cable is connected properly.
The output image
(resolution) changes
automatically.
• When the HDMI monitor is connected, the output image
(resolution) is automatically changed based on information
from the connected monitor
No image is displayed from
the USB.
• The slide switch is not set to the correct image output
(USB). Set the switch correctly.
The image is out of focus.
• The document (object) is too close to the lens. Move the
document (object) slightly away from the lens.
• Auto focus may have difficulty in adjusting correctly.
Adjust the focus manually by using "FOCUS" in the
setting menu.
The intensity of the lighting is insufficient. Press the [ ]
button on the operating panel to adjust the brightness.
Turn on the lamp.
Comments to this Manuals