Elmo Computer Hardware 1.1 User Manual download pdf (Page 50)

Figure 3-29: RS-232 Connection Diagram

3.12.2 CANopen Communication

Notes for connecting the CANopen communication cable:

 Connect the shield to the ground of the host (PC). Usually, this connection is

soldered internally inside the connector at the PC end. You can use the drain wire to

facilitate connection.

 Ensure that the shield of the cable is connected to the shield of the connector used for

communications. The drain wire can be used to facilitate the connection.

 Make sure to have a 120-ohm resistor termination at each of the two ends of the

network cable.

 The Guitar’s CAN port is non-isolated.

Guitar Installation Guide Installation

MAN-GUIIG (Ver. 1.1)

3-36

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

No comments

Elmo Computer Hardware 1.1 User Manual Page 50