Elmo Computer Hardware 1.1 User Manual download pdf (Page 7)

1.1 Warnings

Cleaning after soldering

To avoid damage to the product’s acrylic coating, the Bassoon must not be

cleaned after soldering with soluble solvents or water-based cleaners. For

further details see:

www.elmomc.com/applications/article/Soldering-and-Cleaning_Application-

Note.pdf

To avoid electric arcing and hazards to personnel and electrical contacts,

never connect/disconnect the servo drive while the power source is on.

Power cables can carry a high voltage, even when the motor is not in

motion. Disconnect the Guitar from all voltage sources before it is opened

for servicing.

The Guitar servo drive contains grounding conduits for electric current

protection. Any disruption to these conduits may cause the instrument to

become hot (live) and dangerous.

After shutting off the power and removing the power source from your

equipment, wait at least 1 minute before touching or disconnecting parts

of the equipment that are normally loaded with electrical charges (such as

capacitors or contacts). Measuring the electrical contact points with a

meter, before touching the equipment, is recommended.

1.2 Cautions

The Guitar servo drive contains hot surfaces and electrically-charged

components during operation.

The maximum DC power supply connected to the instrument must

comply with the parameters outlined in this guide.

When connecting the Guitar to an approved 12~195 VDC auxiliary power

supply, connect it through a line that is separated from hazardous live

voltages using reinforced or double insulation in accordance with

approved safety standards.

Before switching on the Guitar, verify that all safety precautions have

been observed and that the installation procedures in this manual have

been followed.

Guitar Installation Guide Safety Information

MAN-GUIIG (Ver. 1.1)

1-2

1 2 3 4 5 6 7 8 9 10 11 12 ... 71 72

No comments

Elmo Computer Hardware 1.1 User Manual Page 7