Elmo QBiC S X1 Instruction Manual download pdf (Page 29)

temperature is stable (10°-30° Celsius or 50°-86° Fahrenheit is ideal). Start to

use again after condensation is completely gone.

If this product is used with the condensation left on the inside of the camera

lens, the product may not record clear images.

■ Built-in microphone

● Operational sounds from this product itself may be recorded when the built-in

microphone is used; however, that is not a malfunction of this product.

■ Precautions for shooting

● Recording time depends on resolution, quality for recording, and so on.

● Do not use this product where photo or video recording is prohibited by law.

Obey all relevant laws. You may be ordered to leave, subjected to fine, be

arrested, and/or forfeit the product.

● Do not use this product for purposes prohibited by law. Obey all relevant laws.

You may be subjected to fine, be arrested, and/or forfeit the product.

■ Treatment

● Do not clean this product with strong solvents, such as thinner and benzene;

they could cause this product to malfunction.

● Wipe with a dry soft cloth.

● When severe contamination is found, first check if the USB connector port and

card slot are properly covered, rinse with fresh water, and wipe with a dry soft

cloth.

■ Luminescent spot and black spot

● This product uses a CMOS area image sensor composed of numerous pixels,

and some of the pixels may not operate normally. Therefore, luminescent

spots or black spots could be witnessed on the output screen. This is not a

defect but a phenomenon peculiar to the CMOS area image sensor.

■ Image data

● This product is composed of precision electronic parts and components. If this

product is handled as follows, the internal data of microSD card could be

destroyed:

- WiFi card and micro SD card are dislodged, or power is turned OFF

while this product is in operation.

- The USB cable (included in the package) comes out during

communication.

● Under those circumstances, ELMO shall not be liable for any damages due to

corruption of or loss of the recorded data.

■ WiFi card and microSD CARD

● When using microSD card other than supplied, format it with this product

before starting to use. Do not use any other device to format. Some microSD

card may not be capable of use even after formatting with this product. The

result varies with manufacturer and type.

● Do not remove WiFi card while the device is accessing micro SD card

(recording). It may cause malfunction or breakdown.

● After use or for storage or transportation, put WiFi card and microSD card into

a case or pouch.

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Elmo QBiC S X1 Instruction Manual Page 29

Comments to this Manuals

Related products and manuals for Bridge cameras Elmo QBiC S X1